Shark WANDVAC WS632ANZ Series Vacuum Cleaner Manual

The Shark WANDVAC WS632ANZ Series is a cordless, lightweight stick vacuum cleaner designed for quick cleanups and versatile floor-to-ceiling cleaning. It features a powerful motor, LED headlights, a washable filter, a crevice tool, and a multi-surface brush roll. Powered by a removable and rechargeable lithium-ion battery. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly & Setup 3. First-Time Use 4. Specifications 5. Controls and Parts 6. Using the Vacuum 7. Maintenance & Cleaning 8. Battery & Charging 9. Storage & Care 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Main body with motor and dust cup, Handle with power button, Removable battery, Charging dock, Crevice tool, Multi-surface brush roll with LED lights.

FeatureDescription
Power ButtonTurns vacuum on/off; located on handle
LED HeadlightsIlluminates dark areas under furniture
Washable FilterCaptures fine dust; can be rinsed and reused
Dust Cup ReleaseButton to empty collected debris
Battery ReleaseButton to remove battery for charging or replacement
Charging DockStores and charges the vacuum
Crevice ToolFor tight spaces and corners
Multi-Surface Brush RollCleans hard floors and low-pile carpets
Wand ReleaseButton to detach wand for handheld use
Battery IndicatorLED lights show remaining charge

Assembly & Setup

Unpack and inspect all contents. Ensure all parts are present.

  1. Insert the battery: Align battery with slot on vacuum body, press until it clicks.
  2. Attach the wand: Insert wand into main body until it clicks securely.
  3. Attach the floor nozzle: Connect multi-surface brush roll to end of wand.
  4. Place on charging dock: Plug dock into wall outlet, place vacuum on dock to charge.

WARNING! Do not use vacuum with damaged cord or plug. Ensure battery is fully charged before first use.

First-Time Use

Charge battery fully before initial use.

  1. Charge: Place vacuum on dock; charge until battery indicator shows full (approx. 3.5 hours).
  2. Power on: Press power button on handle; vacuum will start.
  3. Select mode: Use as stick vacuum for floors; detach wand for above-floor cleaning.
  4. Empty dust cup: Press release button to empty after each use or when full.

CAUTION! Keep hair, loose clothing, and fingers away from brush roll and openings.

Specifications

Controls and Parts

Main Controls: Power Button (On/Off), Battery Release, Dust Cup Release, Wand Release.

Parts Diagram: Main Body, Handle, Battery, Charging Dock, Wand, Floor Nozzle with Brush Roll, Crevice Tool.

Operation: Press power button to start; release to stop. Detach wand for handheld cleaning by pressing wand release button. Empty dust cup by pressing release button at bottom of cup. Remove battery by pressing battery release button.

Using the Vacuum

For floors: Use as stick vacuum with floor nozzle attached. For above-floor: Detach wand for handheld use with crevice tool.

  1. Ensure battery is charged and dust cup is empty.
  2. Press power button to start vacuum.
  3. Move vacuum back and forth over surface; LED lights illuminate debris.
  4. For tight spaces, attach crevice tool to wand or handheld unit.
  5. When finished, press power button to turn off.

Tip: Empty dust cup after each use to maintain suction power.

Maintenance & Cleaning

Regular maintenance ensures optimal performance.

  1. Empty dust cup: Press release button; empty contents into trash.
  2. Clean filter: Remove filter, rinse under cold water, air dry completely before reinserting.
  3. Clear brush roll: Remove debris from brush roll; check for tangled hair or strings.
  4. Wipe exterior: Use dry cloth to clean vacuum body and attachments.

WARNING! Do not use vacuum without filter installed. Ensure filter is completely dry before reuse.

Battery & Charging

Battery: Removable lithium-ion; charges on included dock.

Charging: Place vacuum on dock; LED indicator will glow red while charging, turns off when full. Run Time: Up to 30 minutes depending on surface and mode. Storage: Store vacuum on dock to keep battery charged. Replacement: Use only Shark-approved replacement batteries.

Storage & Care

Store vacuum on charging dock in a dry, indoor location. Keep away from heat and moisture.

CAUTION! Do not store with battery fully depleted; recharge at least every 3 months if not in use.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Copyright © SharkNinja Operating LLC. Shark and WANDVAC are trademarks of SharkNinja Operating LLC. For support, visit sharkclean.com or contact 1-800-798-7398.

Troubleshooting

SymptomPossible CauseCorrective Action
Vacuum won't turn onBattery depleted/not connectedCharge battery on dock; ensure battery is properly inserted.
Reduced suctionFull dust cup/clogged filterEmpty dust cup; clean or replace filter; check for blockages.
Brush roll not spinningDebris tangled around rollTurn off vacuum; clear hair and debris from brush roll.
Battery not chargingDirty contacts/power issueClean charging contacts on vacuum and dock; ensure outlet is working.
Vacuum turns off during useOverheating/full dust cupAllow vacuum to cool; empty dust cup; check filter.

Reset: Remove and reinsert battery if vacuum is unresponsive.

Service: 1-800-798-7398; sharkclean.com

Shark WANDVAC WS632ANZ Series Vacuum Cleaner Manual © - All Rights Reserved 2025